DigiPower 2x500T/02

DigiPower 2x500T

  • LED indicators for signal and operating conditions
  • Monitoring contacts for battery
  • Monitoring contacts for the output amplifier
  • 2 channels in a 19-inch, 2 units of height case
  • Only 272 mm installation depth
  • All feed lines with plug-in, screw terminals
  • Balanced Inputs
  • Automatic standby mode
  • Protection against open circuit, short circuit, over temperature, DC
  • 230 VAC and 24 VDC power supply

DigiPower 2x500T

Dual-channel digital power amplifier with 2x500 watts burst output for professional electroacoustic voice alarm systems.

Continuous operation with max. 2x250 W sine wave power. Maximum power 2x 500 W peak. The electronic protection circuits ensure the necessary safety of the amplifier. In the event of a power failure, it automatically switches to emergency power (Battery 24 V). A front LED indicates this.

A very reliable electronic design guarantees an uncompromising transmission quality and a long-term trouble-free operation. Hardly any waste heat, over 90 % efficiency thanks to digital signal processing.

  • maintenance-free cooling system with optional fan
  • monitoring contacts
  • digital signal processing
  • only 272 mm installation depth
  • only 13 W power consumption in standby mode
  • low battery capacity for emergency operation
  • level control for each channel mounted on the back
  • display of all operating states by LEDs

Inputs and Outputs

Inputs:
24 VDC voltage supply
230 VAC voltage supply
2 x analog audio inputs
2 x control inputs
2 x pilot tone audio inputs

Outputs:
2 x 100 V/50 V power outputs
4 x status signal contacts
230 V................closed when ok
24 V..................closed when ok
CH 1...............closed when ok
CH 2...............closed when ok

Block diagram

DigiPower 2x500T

Specifications

DigiPower 2x500T
TYPE 2x500T
Output Power (RMS) @ 230 VAC (20 Ohm 100 V) 2 x 250 W
Output Power (Burst) @ 230 VAC (20 Ohm 100 V) 2 x 500 W
Output Power (RMS) @ 24 VDC (20 Ohm 100 V) 2 x 240 W
THD + N < 0,29 %
Input sensitivity 1V eff
Input Impedance 10 kOhm
Signal-to-Noise Ratio @ 1 kHz, 250 W, Vol 0.5 85 dB
Output transformer 2 x 50 V / 100 V
Current consumption 230 VAC sinus 100 V @ 40 Ohms 4 A
Current consumption 24 VDC sinus 100 V @ 40 Ohms 26 A 
Current consumption Standby 230 VAC 0.058 A 
Current consumption Standby 24 VDC 0.43 A 
Power consumption in standby mode (230 V) 13 W
Power consumption at full load (230 V) 920 W
Inputs symmetrical on screw terminal
Supply voltage 230 VAC / 24 VDC
Operating temperature -5° C bis +40° C 
Protection circuits DC, short circuit, resonance, over temperature
Frequency response 90 Hz ÷ 21 kHz / -3 dB
Dimensions 482 mm x 88 mm x 272 mm (B x H x T), 19"“ / 2 RU
Weight 17.6 kg

 No responsibility is taken for the correctness of this information - Specifications subject to change.